Simultaneously pressing certain keys on the keypad will
result in the following:
3
and
STATUS
-
FIRE Alarm
6
and
MONITOR
- EMERGENCY Alarm
9
and
F1
- PANIC Alarm
MONITOR
-Door & Window annunciator ON
with beep, ON with speech or OFF
4
ALERT
- The "alert" status indicates the system has been
tripped. The system will remember the "alert" status until
cleared. To clear the "alert" status, simply re-arm the panel.
ANNUNCIATION
- Beep or speech emitted over the phone
or through system speakers to announce activity or report
system status.
ARM
- To turn the security system ON to detect intrusion.
There are three modes, or levels, of arming: AWAY, HOME
or NIGHT.
AWAY
- Arming mode for use when you are AWAY from
the premises. All interior and perimeter devices are armed;
intrusion and/or movement within the premises will activate
the alarm.
BYPASS
- To temporarily remove a zone from the system that
would normally be active when the system is armed. If a
zone is bypassed, it is not part of the system, and will not
initiate an alarm.
CENTRAL STATION
- If your security system is monitored,
this is the agency that receives the incoming burglary or
emergency message from the security system and reports it to
the proper authorities.
COMMUNICATOR
- The device in the control panel that
reports all burglary and emergency alarms to the central
station via telephone lines.
CONTROL PANEL
- The heart of the security system. Only a
qualified security system technician should open the
container which houses the control panel.
DISARM
- To turn the security system OFF or silence alarm
activations, including fire alarms, that may occur while the
system is armed.
DISARM CODE
- The three or four digit number you enter to
disarm the security system. The system will accept 8 different
disarm codes, including disappearing and duress codes.
ENTRANCE DELAY
- Time permitted to enter the armed
premises and disarm the security system before the alarm is
activated. A 20 second delay is set at the factory, but your
installer can program a longer or shorter time, as desired.
GLOSSARY
ANNUNCIATION
ARM
BYPASS
13
CONTROL PANEL
DISARM CODE
ENTRANCE DELAY
DISARM
COMMUNICATOR
PANIC FROM
YOUR PHONE
KEYPAD
ACTIVATIONS
AWAY
CENTRAL STATION
ALERT
GLOSSARY
PANIC FROM YOUR PHONE
KEYPAD ACTIVATIONS
The DESTINY allows 8 different disarm codes. Check with your
installer to find out how many codes are enabled. To enter or
change an auxiliary code;
1. Enter your primary disarm code.
2. Follow steps 2 through 4 above, however, in step 3
instead of entering
01
you will enter the two digit
number of the code you wish to initiate or change.
One or more of your auxiliary codes can be a disappearing
code which is useful for domestic workers, repairmen or
anyone whose access to your home you want to limit. Your
installer can program the number of times a disappearing
code will remain active each time it is assigned.
One or more of your auxiliary codes can be used as a duress
code. Your installer can program your system so that the use of
a duress code will give the appearance of being a normal
disarming code. However, even though no alarm is sounded at
the location of the security system, there will be a silent alarm
signal sent to the central station. For the duress code to function
as designated, no normal codes can be the same as any duress
code.
Anytime you have accessed your system from an on-site
phone, pressing the
0
key five times in a row will initiate a
PANIC alarm.
NOTE:
Never program a disarm code with all zeroes.
1
2
3
S TATUS
P OWE R
STATUS
HOME
AWAY
MONITOR
4
5
6
7
8
9
F1
0
A
H
F2
