AC CRUISE-100 v2.4 (04/2021)
Page 12
6) Control panel
The control panel must be mounted on a vertical panel.
Ensure unrestricted access to the back of the control panel, this will make connections
easier. You should place it in a place where the light indicators are visible. Example: below or
on the sides of cupboards, under the chart or centre table, on the front panel of a rear berth
etc.
Hose for connecting the high-pressure membrane outlet to the high-pressure
control valve on the back of the front panel. (Black high-pressure hose supplied)
Hose for connecting the water outlet of the membranes to the inlet of the probe of
the panel. (Outside diameter Ø 10mm pipe supplied)
Hose for connecting the fresh water outlet of the panel to the tanks, dispensing
clarinet or water inlet or with a tee provided that there is no valve on the outlet of the water
tank. (Outside diameter Ø 10mm pipe not supplied, use preferably Tricoclair)
Hose to connect the discharge of panel. To be connected preferably to a water
disposal system like the evacuation of a sink, washbasin, cockpit etc. In this case, do not
forget to open the drain valves during use. (Ø 12mm inside diameter pipe not supplied)
Cables to be connected:
- 230V (or 120V) power supply. The provided circuit breaker must be placed on this line,
if you do not already have one available on your 230V switchboard
- Motor power supply 230V (or 120V).
See instructions for connection on page 10.
