DesignTech AirWolf, Installation Manual

Page: 20 / 36

20
v4.2
9-5. Orange : Brake Input
This wire shuts the unit off if the brake is pressed. This wire MUST be installed for safety
reasons! Connect the Orange brake input wire to the wire on the brake pedal switch which
shows 12 volts ONLY when the brake is being pressed. (When the brake is not pressed
the correct wire will not have power.) NOTE: This unit can not turn the vehicle off when the
vehicle is running with the ignition key.
9-3. Gray : Door pin Switch Input
One of the door input wires MUST be installed to allow the unit to properly function,
including the programming and alarm functions. If your vehicle uses a positive trigger door
pin switch, connect this wire to a wire in the vehicle which shows 12 V
when any door is open, and 0V when all doors are closed. NOTE: If your
vehicle uses a negative trigger door pin switch see “#2 Gray/Black Negative
door pin switch wire.” The AirWolf system will not properly function without
one of these door pin wires connected.
9-4. Purple : hood pin Switch Input
This wire is used to detect opening of the hood via a pin switch that is included with the
product. This wire MUST be installed for safety reasons. Also - Dip Switch One is internally
connected to the hood input wire. This makes it possible to perform programming options
requiring switch one to be placed on without accessing the module. (Hood Open = Switch
One Down. Hood Closed = Switch One Up) NOTE: This unit can not turn the vehicle off
when the vehicle is running with the ignition key.
Purple
Brown (Con2 #12)
dome light output
( door Input)