1.
Locate two wires in the switch housing (white and blue labeled “ for light”).
2.
Connect them to the light kit wire connectors (Fig. 12)
White to white
Blue to blue
Secure all splices with electrical tape to prevent connectors from vibrating loose during
fan operation.
3.
Carefully push all wires back into the switch housing. Then attach housing cover
plate to switch housing with the 3 screws provided.
4.
Attach the glass shades to the light kit, using 3 thumb screws per shade
(provided). Do not over-tighten the thumb screws as glass may break. Install (40
watt max). light bulbs (not provided). Glass shade & thumb screws are not
provided on the spot light fan.
5.
Restore power and your light kit is ready for operation.
6.
If the light kit does not work, turn off the electricity and lower the canopy on your
ceiling fan. Make sure the blue wire is connected to black household wires
(please refer to electrical connections section in this manual).
INSTALLING GENERAL TURTLE LIGHT KIT (OPTIONAL)
Page 11
This light kit is for
reference only, some
model get different
light kit, but they are
installed in similar
way
WARNING:
All suspended fan (not hugger) with 190W light limiter. If the total wattage of the light
bulb (s) is more than 190W, the light is OFF until the total wattage reduce to below
190W.
