3.
Tighten motor set screw. Check the strength of this connection (pre-tightened at
factory) by holding the motor housing in position and turning the downrod counter
clockwise. If this connection slips, retighten motor setscrew and locknut. Follow the
same procedures as mentioned above for downrod setscrew.
4. Install ball into hanger bracket opening. The tab opposite of the hanger bracket
opening should fit in slot on ball (Fig 8) .
5.
Make wire connections (refer to section titled” Electrical Connections”)
For
cUL-listed fan, please secure the safety cable to the junction box.
6. Slide canopy up, and fasten to hanger bracket with the 4 screws provided.
WARNING: To avoid damaging the blade arms and blades, do not install either until
fan is fastened to ceiling. To avoid motor shift, handle fan by downrod or switch
housing only.
Page 7
DOWNROD SETSCREW
Lock Nut
Motor Setscrew
Fig.7
Hanger Bracket
Safely Cable(For
cUL_listed fan only)
Tab
Ball
Ball Slot
Fig.8
