5
6. MAKE THE ELECTRIC
CONNECTIONS
WARNING: To avoid possible electrical
shock, be sure electricity is turned off at
the main fuse box before wiring.
NOTE: Remove cover by snapping off from
top or bottom. Install 12V battery into wall
remote. Duracell MN21/Everady A23/GP
23A all 12V. (Fig. 10)
NOTE: This remote control unit is
equipped with 16 code combinations to
prevent possible interference from or to
other remote units. The frequency
switches on your receiver and transmitter
have been preset at the factory. Please
recheck to make sure the switches on
transmitter and receiver are set to the
same position, any combination of settings
will operate the fan as long as the
transmitter and receiver are set to the
same position. (Fig. 11)
Step 1. (Fig. 12) Insert the receiver into
the mounting bracket with the flat side
of the receiver facing the ceiling.
Figure 10
Figure 9
Figure 11
Figure 12
Receiver
Hanger
bracket
CHANGING THE DOWNROD (OPTIONAL)
NOTE: Your fan comes with a 6" downrod
attached to the hanger ball. In addition
you have been provided with a 4"
downrod to use if desired. If you choose to
use the 4" downrod, perform the following
steps:
1. Remove the hanger ball from the 6"
downrod by loosening the set screw at the
top of the downrod which holds the
hanger ball to the downrod. (fig. 9)
2. Slide the hanger ball down the downrod
and remove the support pin. (fig. 9)
3. Insert the support pin in the holes at the
top of the 4" downrod and slide the
hanger ball up the 4" downrod. Make sure
the support pin is properly seated in the
grooves in the top of the hanger ball.
4. Tighten the set screw firmly.
Downrod
Cross pin
Hanger
ball
Set screw
Code switch
ON
ON
