DESCO ASIA
© 2019 DESCO INDUSTRIES INC
TB-9096 Page 5 of 8
Employee Owned
Note 1: Use mechanical switch or photo
coupler or relay for external input. If
the grounding potential of external
device to use for external input and
the grounding potential of this
product use are different, the
external device used for external
input should have an insulated
on/off procedure for the 0V line.
・
Be sure to carry out the grounding procedure (according to the class D procedure).
・
Check that the Frame of the Machine is grounded. If it is not grounded, be sure to follow the grounding class
D procedure. When you contact it with this product, connect 0V (black) and the grounding point of the power
supply and signal cable to being common. But when 0V and the grounding point are not connected to be
common, do not connect 0V line to the grounding point. And when you use an optional AC adapter, this
product does not need to be properly grounded.
Air Piping:
・
Use clean dry compressed air to deliver the ionized air.
・
Attach an air tube (with an outside diameter of Φ6 mm) to the air inlet of the Ionizer.
・
Connect the air tube via the regulator to the air supply (Air compressor).
・
Supply cleaned air (not containing water or oil) to the Ionizer.
6. Operation:
Caution
・
Always use air when supplying power to the ionizer. Otherwise, the ozone concentrations inside the Ionizer will
increase due to electric discharge, which may cause detrimental effect on the main body and its surroundings.
1. Install the equipment at a designated place, and perform power supply wiring, grounding wiring, and air
piping.
2. Supply DC24V through the power source connector of the equipment. The power source of high voltage
starts and corona discharge is generated at the discharge electrode, producing air ions. When the power
source is activated, the green LED (in the normal condition) is on.
3. Open the main valve of the air equipment (installed by your company), and supply air to the nozzle with
designated pressure after adjusting the Air pressure. Ionized air is blown out from the nozzle and static
electricity of the charged objects placed in the air-flow is neutralized and removed. Pay attention to
excessive air pressure, which will lower the effect of removing electricity. (See the table under "Air Pressure
Working Range" under "4. Specifications" for the working range of air pressure.
4. When you attach the tube to the nozzle, move the tip of the tube closer to the charged object and blow ion
air.
