www.desatech.com
116010-01E
12
glass door insTallaTion
Figure 20 - Installing Top Door Frame
Top Door
Rail
Smoke Shelf
IMPORTANT: Install glass door
frame before installing glass
door.
INSTALLING DOOR FRAMES
1. Remove screws from smoke shelf (see
Figure 20).
2. Mount top door frame and secure with
screws removed in step 1.
3. Remove center brick by pulling ring handle
(see Figure 21).
4. Remove ash box.
5. Remove three screws located at front of
firebox (see Figure 21).
6. Align bottom rail mounting holes with
holes at front of firebox and secure with
screws removed in step 5.
7. Place ash box in place. Replace center
brick.
DOOR ADjUSTMENT
Remove doors and slightly loosen lower pivot
clips and upper spring clips. Replace doors and
fully close them. Use 1/8" shims (any material)
to level doors. Once proper setting is achieved,
carefully open doors enough so that you can
access spring clips with a phillips screwdriver.
Tighten screws. See Figure 23.
Figure 22 - Installing Bi-Fold Doors
Spring
Clip
Insert Pin
into Spring
Clip
Pivot
Hole
Insert
Bottom
Pivot Pin
into Hole
Fold Door
and Slide
Top Pins
Into Track
Figure 23 - Adjusting Bi-Fold Doors
Figure 21 - Installing Bottom Door Rail
Bottom
Door Rail
Ash Box
Center
Brick
Ring
Handle
Screws
INSTALLING GLASS DOORS
Spring clips have been installed but some
adjustments may be needed. If doors do not
close properly or do not appear straight, see
Door Adjustment
.
1. With bi-fold doors completely folded, insert
bottom pivot pin into pivot hole located
near bottom corner of front face opening
and swing door to vertical position making
sure top pins slide into door track. Door
is installed when top door pin snaps into
spring clip (see Figure 22).
2. Repeat step 1 for remaining door.
If you find the doors do not close properly or
do not appear level or straight, proceed with
section on door adjustment.
Spring
Clip
