![background image](http://html1.mh-extra.com/html/desa/unvented-vent-free-natural-gas-fireplace/unvented-vent-free-natural-gas-fireplace_owners-operating-and-installation-manual_2486410010.webp)
10
101968
INSTALLING
Continued
ASSEMBLING AND ATTACHING BRASS TRIM
Note:
The instructions below show assembling and attaching brass trim to fire-
place. You cannot attach the brass trim as described below for built-in installation
(see page 13).
1. Remove packaging from three pieces of brass trim.
2. Locate four brass screws, two adjusting plates with set screws, and two shims
in the hardware packet.
3. Align shim under adjusting plate as shown in Figure 5.
4. Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim
(see Figure 5).
5. Slide other end of adjusting plate/shim in slot on mitered edge of side brass
trim (see Figure 5).
6. While firmly holding edges of brass trim together, tighten both set screws on
the adjusting plate with slotted screwdriver.
7. Repeat steps 1 through 6 for other side.
Figure 6 - Attaching Brass Trim to Fireplace
Screws
Assembled
Brass Trim
8. Place the assembled trim onto fireplace cabinet. Attach to fireplace with brass
screws included in hardware package (see Figure 6).
Side Brass Trim
Top Brass Trim
Slot
Mitered Edge
Slot
Shim
Set Screws
Adjusting
Plate
Figure 5 - Assembling Brass Trim
Summary of Contents for UNVENTED (VENT-FREE) NATURAL GAS FIREPLACE
Page 38: ...38 101968 NOTES...
Page 39: ...39 101968 NOTES...