background image

6

598-1168-03

SYMPTOM
Light  stays  on 
continuously.

Light flashes on 
and off.

Light  does  not 
stay on in Man-
ual mode.

POSSIBLE CAUSE

1.  There  is  a  heat  source  like  an 

air  vent,  dryer  vent,  or  brightly-
painted, heat-reflective surface in 
the coverage area. (Install shield 
on sensor in the direction of heat 
source.)

2.  Sensitivity is set too high. (Reduce 

sensitivity.)

1.  Sensor is in the Test mode. (While 

in TEST mode, light only stays on 
for 5 seconds.)

1.  Nearby large, light-colored objects 

reflecting  light  may  trigger  the 
shut-off feature. Do not point other 
lights at the sensor.

POSSIBLE CAUSE

1.  Light switch is turned off.
2.  Bulbs are loose or burned out.
3.  Fuse is blown or circuit breaker 

is turned off.

4.  Daylight turn-off is in effect (re-

check after dark).

5.  Incorrect circuit wiring, if this is 

a new installation.

1.  Sensor  may  be  installed  in  a 

relatively dark location.

2.  Sensor  is  in  Test.  (Set  control 

switch to an ON-TIME position.)

1.  Sensor  may  be  sensing  small 

animals  or  automobile  traffic. 
(Reduce sensitivity.)

SYMPTOM
Light  will  not 
come on.

Light  comes  on 
in daylight.

Light  comes  on 
for  no  apparent 
reason.

TROUBLESHOOTING GUIDE

TECHNICAL SERVICE

Please call 1-800-858-8501 for assistance before returning product to store.

If you experience a problem, follow this guide. You may also want to visit our Web site at: 

www.desatech.

com.

 If the problem persists, call* for assistance at 

1-800-858-8501,

 7:30 AM to 4:30 PM CST (M-F). 

You may also write* to:
DESA Specialty Products™
P.O. Box 90004, Bowling Green, KY 42102-9004
ATTN: Technical Service Specialty Products
* If contacting Technical Service, please have the following information available: Model Number, Date of 
Purchase, and Place of Purchase.

No Service Parts Available for this Product

THREE YEAR LIMITED WARRANTY

This is a “Limited Warranty” which gives you specific legal rights. You may also have other rights which vary from state to state or 
province to province.
For a period of three years from the date of purchase, any malfunction caused by factory defective parts or workmanship will be 
corrected at no charge to you.

Not Covered - 

Repair service, adjustment and calibration due to misuse, abuse or negligence, light bulbs, batteries, and other ex-

pendable items are not covered by this warranty. Unauthorized service or modification of the product or of any furnished component 
will void this warranty in its entirety. This warranty does not include reimbursement for inconvenience, installation, setup time, loss of 
use, unauthorized service, or return shipping charges.
This warranty covers only DESA Specialty Products™ assembled products and is not extended to other equipment and components 
that a customer uses in conjunction with our products.
THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTY, 
REPRESENTATION OR CONDITION OF MERCHANT ABILITY OR THAT THE PRODUCTS ARE FIT FOR ANY PARTICULAR PUR-
POSE OR USE, AND SPECIFICALLY IN LIEU OF ALL SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES.
REPAIR OR REPLACEMENT SHALL BE THE SOLE REMEDY OF THE CUSTOMER AND THERE SHALL BE NO LIABILITY ON 
THE PART OF DESA SPECIALTY PRODUCTS™ FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, 
INCLUDING BUT NOT LIMITED TO ANY LOSS OF BUSINESS OR PROFITS, WHETHER OR NOT FORESEEABLE. Some states 
or provinces do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may 
not apply to you. Proof of purchase is required for warranty claims.

Summary of Contents for Portfolio PF-4305













Reviews: