14
105935
VENT-FREE NATURAL GAS HEATER
MR10NT
™
OBSERVED PROBLEM
Burner plaques do not light after ODS/pilot
is lit
Delayed ignition of burner plaques
Burner backfiring during combustion
POSSIBLE CAUSE
1. Burner orifice(s) is clogged
2. Burner orifice(s) diameter is too small
3. Inlet gas pressure is too low
1. Manifold pressure is too low
2. Burner orifice(s) is clogged
1. Burner orifice(s) is clogged or damaged
2. Inlet gas pressure is too low
3. Burner damaged
4. Gas regulator defective
REMEDY
1. Clean burner orifice(s) (see Cleaning
and Maintenance, page 12) or replace
burner orifice(s)
2. Replace burner orifice(s)
3. Contact local natural gas company
1. Contact local natural gas company
2. Clean burner orifice(s) (see Cleaning
and Maintenance, page 12) or replace
burner orifice(s)
1. Clean burner orifice(s) (see Cleaning
and Maintenance, page 12) or replace
burner orifice(s)
2. Contact local natural gas company
3. Replace burner
4. Replace gas regulator
1. Plaque damaged
2. Inlet gas pressure is too low
3. Control knob set too low
1. Residues from manufacturing processes
1. Metal expanding while heating or
contracting while cooling
Burner plaques do not glow
Slight smoke or odor during initial operation
Heater produces a clicking/ticking noise
just after burner is lit or shut off
TROUBLESHOOTING
Continued
1. Replace burner
2. Contact local natural gas company
3. Turn control knob to higher setting
1. Problem will stop after a few hours of
operation
1. This is common with most heaters. If
noise is excessive, contact qualified
service person
White powder residue forming within burner
box or on adjacent walls or furiture
1. When heated, vapors from furniture
polish, wax, carpet cleaners, etc, turn
into white powder residue
1. Turn heater off when using furniture
polish, wax, carpet cleaners, or similar
products
