www.desatech.com
124434-01A
11
CLEANINg AND MAINTENANCE
Continued
REPLACING FLAME GENERATION LED
1. Remove trim if applicable.
2. Remove fireplace from mantel.
3. Follow steps 2 and 3 under
Replacing Log
,
page 9.
4. Remove screws from sides and back of
bottom panel of firebox.
5. Gently lay unit on its back.
6. There are several wires attached to bot-
tom panel. Carefully remove panel.
7. Disconnect wires from motor and LED
drum assembly.
8. Remove screws from bottom panel to
remove assembly.
9. If motor on assembly fails, remove cotter
pin using pliers. Remove screws from
motor and discard.
10. Install new motor. Replace screws and
cotter pin.
11. Hold LED drum assembly in place on
bottom panel and replace screws.
12. Reattach wires to motor and LED drum.
Note: LED drum wires are polarity sensi-
tive and must be connected correctly.
White wire plugs onto left terminal and red
wire plugs onto right terminal. Motor wires
can be connected to either terminal
.
13. Replace fireplace bottom panel. Set fire
-
place upright and replace screws.
14. Replace log, glass and bracket.
15. Reinstall fireplace and replace trim.
CLEANING OR REPLACING BACK
SCREEN (GLASS)
1. The glass is cleaned in the factory dur-
ing assembly. During shipment, instal-
lation, handling, etc. the glass surface
may collect dust particles. These can be
removed by buffing lightly with a clean
damp cloth (water only). Glass should be
completely dried with a lint free cloth or
paper towel.
2. In the event of glass breakage, vacuum all
remaining glass pieces with a shop vac.
DO NOT VACUUM WHILE PIECES ARE
HOT. Replace glass only with replacement
part specifically for this heater. Never
substitute material. Only fully tempered
soda lime safety glass may be used on
this heater.
3. To access glass to clean or replace,
follow steps 1 and 7 under
Replacing
Flame Generation LED
. Set aside bottom
panel.
4. Remove screws holding log base to unit.
Carefully remove log base from unit.
5. Using gloves, gently remove glass panel
by sliding it toward you.
6. Clean glass as instructed in step 1 or
replace glass.
7. Using gloves, reinstall glass by gently
sliding, smooth side toward fireplace front,
into brackets on either side that hold glass
in place.
8. Replace log base.
9. Follow steps 12 and 15 under
Replacing
Flame Generation LED
.
LED Drum
Assembly
Screws
White Wire
Red
Wire
Figure 16 - Flame Generation LED Drum
Assembly
Motor
Figure 15 - Replacing Settings Control
Board
Screws
Settings
Control Board
Cotter Pin
