![background image](http://html.mh-extra.com/html/desa/hdle2824nr/hdle2824nr_owners-operation-and-installation-manual_2485987023.webp)
www.desatech.com
119921-01F
23
CLEANING AND MAINTENANCE
5. Blow air into the primary air holes on the
injector holder.
6. In case any large clumps of dust have now
been pushed into the burner repeat steps
3 and 4.
Clean the pilot assembly also. A yellow tip
on the pilot flame indicates dust and dirt in
the pilot assembly. There is a small pilot air
inlet hole about two inches from where the
pilot flame comes out of the pilot assembly
(see Figure 36). With the unit off, lightly blow
air through the air inlet hole. You may blow
through a drinking straw if compressed air is
not available.
Burner
Tube
Injector
Holder
Primary Air
Inlet Holes
Ports/Slots
Propane/LP Gas
Pilot Assembly
Pilot Air
Inlet Hole
Pilot Assembly
Pilot Air
Inlet Hole
Natural Gas
LOGS
• If you remove logs for cleaning, refer to
Installing Logs,
page 17, to properly replace
logs.
• Replace log(s) if broken or chipped (dime-
sized or larger).
MAIN BURNER
Periodically inspect all burner flame holes with
the heater running. All slotted burner flame
holes should be open with yellow flame pres-
ent. All round burner flame holes should be
open with a small blue flame present. Some
burner flame holes may become blocked by de-
bris or rust, with no flame present. If so, turn off
heater and let cool. Remove blockage, blocked
burner flame holes will create soot.
Figure 35 - Pilot Inlet Air Hole
Figure 34 - Pilot Inlet Air Hole
WARNING: Turn off heater
and let cool before cleaning.
CAUTION: You must keep
control areas, burner and circu
-
lating air passageways of heater
clean. Inspect these areas of
heater before each use. Have
heater inspected yearly by a quali
-
fied service person. Heater may
need more frequent cleaning due
to excessive lint from carpeting,
bedding material, pet hair, etc.
WARNING: Failure to keep
the primary air opening(s) of
the burner(s) clean may result in
sooting and property damage.
BURNER INjECTOR HOLDER AND
PILOT AIR INLET HOLE
The primary air inlet holes allow the proper
amount of air to mix with the gas. This provides
a clean burning flame. Keep these holes clear
of dust, dirt, lint and pet hair. Clean these air in-
let holes prior to each heating season. Blocked
air holes will create soot. We recommend that
you clean the unit every three months during
operation and have heater inspected yearly by
a qualified service person.
We also recommend that you keep the burner
tube and pilot assembly clean and free of dust
and dirt. To clean these parts we recommend
using compressed air no greater than 30 PSI.
Your local computer store, hardware store or
home center may carry compressed air in a
can. If using compressed air in a can, please
follow the directions on the can. If you don't
follow directions on the can, you could dam-
age the pilot assembly.
1. Shut off unit, including pilot. Allow unit to
cool for at least thirty minutes.
2. Inspect burner, pilot and primary air inlet
holes in rear burner for dust and dirt (see
Figure 34).
3. Blow air through the holes in the burner.
4. Remove any large particles of dust, dirt,
lint or pet hair with a soft cloth or vacuum
cleaner nozzle.