www.desatech.com
118116-01D
15
GLASS DOOR INSTALLATION
5. Place rail back on bricks and align holes.
Secure using 9 concrete screws provided
with glass door kit.
6. Secure mounting clips to top and bottom
rails (see Figure 24).
Figure 24 - Mounting Door Retaining
Clips
Retaining
Clip
Top Rail
Bottom Rail
Figure 23 - Securing Door Rails to
Fireplace
Bottom Rail
(Use as a
Template before
Drilling)
Concrete
Screws
Top Rail
Drill Holes
into Bricks
Remove Screws
then Replace to
Secure Top Rail
Installing Glass Doors
After spring clips have been installed some
adjustments may be needed. Install doors
using the following steps:
1. With bi-fold doors completely folded, in-
sert bottom pivot pin into bottom retaining
clip located at far left and far right side of
bottom rail. Swing door to vertical posi-
tion making sure top pins slide into top
door rail. Door is installed when top door
pin snaps into spring clip (see Figure 25,
page 16).
2. Repeat step 1 for remaining door.
,I\RX¿QGGRRUVGRQRWFORVHSURSHUO\RUGR
not appear level or straight, proceed with sec-
tion on door adjustment, page 16.
IMPORTANT: Install top and bot-
tom rails and hardware before
installing glass door panels.
DOOR AND RAIL INSTALLATION
FOR MODELS BDMO48E, BDMO48G
AND BDMO48C
IMPORTANT:
This optional glass door kit can
127EHXVHGZLWK\RXU¿UHSODFHLI\RXKDYH
installed the optional Ash Lip Kit.
Rail installation
1. Remove screws securing top face to
¿UHER[VHH)LJXUH
2. Align holes on rail to be installed at top
and replace screws.
Note: Door rails are
LGHQWLFDOXQWLOVSULQJFOLSVDUHLQSODFH
3. Using remaining door rail as a template,
place along front row of bricks at bottom
PDNLQJVXUHUDLOIURQWVXUIDFHLVÀXVKZLWK
¿UHSODFHERWWRPIDFHVXUIDFH0DUNKROH
centers and remove rail (see Figure 23).
4. Drill 9 - 5/32" diameter holes about 1"
deep directly into bricks using a 5/32"
concrete drill bit (not provided).
