111826-02C
For more information, visit www.desatech.com
12
OPERATING APPLIANCE (REMOTE-READY MODELS)
Lighting Instructions (Cont.)
Remote Control Operations
OPERATING APPLIANCE
Continued
9. Slightly push in and turn control knob counterclockwise
to the ON position.
10. Wait one minute and switch selector switch to the ON po-
si tion to light burners.
Note:
AUTO is not func tion al.
11. Set fl ame adjustment knob to any lev el be tween HI and
LO.
CAUTION: Do not try to ad just heating levels by
using the equipment shutoff valve.
WARNING: Make sure the selector switch is in the
OFF po si tion when you are away from home for long
periods of time. Appliance will come on au to mat i cal ly
with selector switch in the ON position.
Shutting Off Appliance
1. Turn control knob clockwise
to the OFF po-
si tion.
2a. Set selector switch in the OFF po si tion.
2b.
If Using Optional Hand-Held Re mote:
Set selector switch
in the OFF po si tion to pre vent drain ing battery.
Shutting Off Burner Only (pilot stays lit)
You may shut off the burners and keep the pilot lit by doing
one of the fol low ing:
1. Turn control knob clockwise
to the PILOT po-
si tion.
2. Use remote control manual OFF button.
3. Set selector switch in the OFF po si tion.
Figure 14 - Pilot (Propane/LP)
Ignitor
Electrode
Pilot
Burner
Pilot (Natural)
Ignitor
Electrode
Pilot
Burner
TO TURN OFF GAS TO APPLIANCE
MANUAL LIGHTING PROCEDURE
1. Fol low steps 1 through 6 under Light ing In struc tions.
2. Depress control knob and light pilot with match.
3. Keep control knob pressed in for 30 seconds after lighting
pilot. After 30 seconds, release control knob. Now follow
steps 9 through 11, Lighting In struc tions, column 1.
O
F
F
PI
LOT O
N
LO
IH
AUTO
OFF
ON
Control Knob
Ignitor Button
Flame Adjustment Knob
Selector Switch in
OFF Position
REMO
TE OFF ON
Remote Control Operation
GHRC Series Operation:
1. After lighting, let pilot fl ame burn for about one minute.
Turn control knob to ON position. Adjust fl ame ad just ment
knob anywhere between HI and LO. Slide the se lec tor
switch to the RE MOTE po si tion.
Note:
The burn ers may
light if hand-held re mote ON button was on when se lec tor
switch was last turned off. You can now turn the burn ers
on and off with the hand-held re mote con trol unit.
IMPORTANT:
Do not leave the se lec tor switch in the RE-
MOTE or ON position when the pilot is not lit. This will
drain the battery.
2. Press the ON/OFF button to turn the burners on and off.
When turning burners off, the pilot will remain lit.
IMPORTANT:
Be sure to press the ON/OFF buttons on the
hand-held remote control unit for up to 3 sec onds to assure
proper operation.
Note:
All additional re mote control accessories must be pur-
chased sep a rate ly (see Ac ces so ries, page 22). Fol low instructions
included with the re mote control.
REMOTE CONTROL OPERATION
Selector Toggle Switch
Remote Control
Figure 15- Setting the Selector switch, Control Knob, and Flame
Adjustment Knob for Remote Operation
