www.desatech.com
123551-01D
17
INSTALLATION
Continued
3. Place log #3 on left side of base and onto
alignment screw to right of rear burner
(see Figure 18). Log #3 will wrap around
left end of rear burner.
4. Place log #4 onto two alignment screws
to the rear of base (see Figure 19).
5. Place back of log #5 on notch in log #4 (as
shown in Figure 20), across back part of
log #1 and onto pin on log #2 (see Figure
18 and Figure 20).
6. Place log #6 onto two pins on log #1
(ember bed) and rest back of log #6 on
back log #4 (see Figure 20).
Figure 18 - Installing Log #2 (Right) and
Log #3 (Left)
Figure 19 - Installing Log #4
Figure 20 - Installing Log #5 (Right) and
Log #6 (Left)
Log #5
Log #6
Log #4
Log #3
Log #1
Log #2
Log #4
Log #3
Log #1
Log #2
Log #3
Log #1
Log #2
Figure 21 - Attaching Grate to Base
Assembly
Grate
Slots in Base
ATTACHING GRATE TO BASE
ASSEMBLY
Locate the two slots in the front of the base
assembly. Carefully slide the decorative grate
into these slots (see Figure 21).
ADDING LAvA ROCK
Place lava rock around base of heater if de-
sired. Be sure not to cover the control knobs
or air inlet openings on the front of heater.
