www.desatech.com
120044-01D
16
2. Carefully remove logs and set aside.
3. Locate mounting screws on sides of heat-
er base assembly and remove screws. Set
screws aside for reinstallation.
4. Disconnect gas line from heater base as
shown in Figure 11, page 13.
WARNING: A qualified ser-
vice person must connect and
disconnect gas to heater. Follow
all local codes.
5. Remove heater base from fireplace.
6. Install receiver bracket to base with phil-
lips screws provided in hardware kit as
shown in Figure 18.
7. Disconnect jumper wire from control valve at
TPTH and TH locations (see Figure 19).
8. Install remote receiver into receiver
bracket using pads and push button clips
provided with receiver (see Figure 20,
page 17).
9. Connect wires to control valve at the TPTH
and TH locations as shown in Figure 21,
page 17.
Note: Make sure excess wire
does not interfere with burner or pilot.
10. If heater was removed from fireplace
before installation of remote accessory,
see
Installing Heater Base Assembly
on
page 13 to reinstall heater into fireplace.
Test gas connection for leaks (see
Check-
ing Gas Connections
, page 15).
11. If logs were removed from heater for in-
stall remote accessory, replace logs (see
Installing Logs
, page 17).
INSTALLATION
Continued
Figure 19 - Disconnecting Jumper Wire
From Control Valve
Jumper
Wire
Control Valve
Figure 18 - Installing Remote Receiver
Bracket
Remote Receiver Bracket
Phillips
Screws
4. Check all joints from equipment shutoff
valve to gas control (see Figures 16 or 17).
Apply noncorrosive leak detection fluid to
all joints. Bubbles forming show a leak.
5. Correct all leaks at once.
6. Light heater (see
Operation
, page 18).
Check all other internal joints for leaks.
7. Turn off heater (see
To Turn Off Gas to
Appliance
, page 19).
Gas Meter
Figure 17 - Checking Gas Joints (Natural
Gas Only)
Control Valve
Location
Equipment
Shutoff Valve
Figure 16 - Checking Gas Joints
(Propane/LP Only)
Control Valve
Location
Propane/LP
Supply Tank
Equipment
Shutoff Valve
INSTALLING OPTIONAL REMOTE
ACCESSORIES
Installing Remote Receiver
Remote control accessories are available
separately (see
Accessories
, page 31).
1. If unit is already installed in fireplace,
continue with these instructions. If unit
has not been installed in fireplace, go to
step 6 and continue installation of remote
accessory.
WARNING: Turn off heater
and let cool before handling any
part of heater. Make sure gas is
turned of to unit.
