901273-01D
11
11
For more information, visit www.desatech.com
For more information, visit www.desatech.com
During the 2-3 hour appliance break-in period, you may detect
an odor from the appliance as the various paints and com-
pounds used in the manufacturing of this log set cure. This is a
normal and temporary situation that is not cause for alarm.
However, you may want to provide extra ventilation to the room
during this time.
To ensure proper curing of the logs:
• Ignite a 2" flame and maintain it for 1 hour.
• Burn the logs in consecutive 1 hour periods raising the flame
an additional 2" to full flame height for a total of three hours.
CURING LOGS
OPERATING APPLIANCE
Continued
TO TURN OFF GAS TO APPLIANCE
Shutting Off Appliance
Slightly push in and turn control knob clockwise
to the
OFF position.
Shutting Off Burner Only (pilot stays lit)
You may shut off the burner and keep the pilot lit by doing one
of the following:
1.
Slightly push in and turn control knob clockwise
to the PILOT position.
2.
If Using Optional Hand-Held Remote or Wall Switch:
Set switch to OFF position.
OPTIONAL REMOTE OPERATION
Note:
All remote control accessories must be purchased sepa-
rately. Follow instructions included with the remote control.
NOTICE: You must light the pilot before using the hand-
held remote control unit. See
Lighting Instructions,
page 10.
1.
After lighting, let pilot flame burn for about one minute.
Turn control knob to ON position. Slide the selector switch
to the REMOTE position.
Note:
The burner may light if
hand-held remote ON button was on when selector switch
was last turned off. You can now turn the burner on and
off with the hand-held remote control unit.
IMPORTANT:
Do not leave the selector switch in the RE-
MOTE position when the pilot is not lit. This will drain the
battery.
IMPORTANT:
Be sure to press the ON/OFF buttons on the
hand-held remote control unit for up to 3 seconds to assure
proper operation.
GHRC Operation:
2.
Press the ON/OFF button to turn the burner on and off.
When turning burner off, the pilot will remain lit.
GWMS2 WALL MOUNTED SWITCH
(OPTIONAL)
This wall switch works just like the conventional light switch.
Flip the switch up for on and down for off.
Note:
Make sure that this switch is not in a position to be
mistaken for a light switch. This may result in the log set being
inadvertently turned on without the proper precautions being
taken. See installation instructions on page 8 of this manual.
OPERATING APPLIANCE
To Turn Off Gas To Appliance
Curing Logs
Optional Remote Operation
GWMS2 Wall Mounted Switch
