![background image](http://html1.mh-extra.com/html/desa/comfort-glow-cf26nta/comfort-glow-cf26nta_owners-operation-and-installation-manual_2486306020.webp)
www.desatech.com
113896-01D
0
BURNER FLAME PATTERN
Figure 32 shows a correct burner flame pattern.
Figure 33 shows an incorrect burner flame pattern.
If burner flame pattern is incorrect,
•
turn heater off (see
To Turn Off Gas to Appliance
)
• see
Troubleshooting
, page 22
OPERATING FIREPLACE
Continued
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Heater
Turn control knob clockwise
to the OFF
position.
Shutting Off Burner Only (pilot stays lit)
Turn control knob clockwise
to the PI-
LOT position.
THERMOSTAT CONTROL
OPERATION
The thermostat control knob can be set to any
comfort level between HI and LO. The ther
-
mostat will gradually modulate the heat output
and flame height from higher to lower settings
or pilot, in order to maintain the comfort level
you select. The ideal comfort setting will vary
by household depending upon the amount of
space to be heated, the output of the central
heating system, etc.
Note:
Selecting the HI setting with the control
knob will cause the burner to remain fully on,
without modulating down in most cases.
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 6 under
Lighting
Instructions,
page 19.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow step 8 under
Lighting Instructions,
page 19.
INSPECTING BURNERS
Check pilot flame pattern and burner flame pat
-
terns often.
PILOT FLAME PATTERN
Figure 30 shows a correct pilot flame pattern.
Figure 31 shows an incorrect pilot flame pattern.
The incorrect pilot flame is not properly heating
the thermocouple. When the thermocouple cools,
the heater will shut down.
If pilot flame pattern is incorrect, as shown in
Figure 31
•
turn heater off (see
To Turn Off Gas to Appliance
)
• see
Troubleshooting
, page 22
Figure 30 - Correct Pilot Flame Pattern
(propane/LP ignitor shown)
Figure 31 - Incorrect Pilot Flame Pattern
(propane/LP ignitor shown)
Pilot Burner
Thermocouple
Pilot Burner
Thermocouple
Figure 32 - Correct Flame Pattern with
Control Knob Set to High Flame
Figure 33 - Incorrect Flame Pattern with
Control Knob Set to High Flame
Approx. 3-6"
Above Top
of Logs
More Than
8" Above
Top of Logs
Note:
The correct pilot flame on natural gas units
will have a slight curve, but flame should be blue
and have no yellow or orange color.
f i r e - p a r t s . c o m