![background image](http://html1.mh-extra.com/html/desa/comfort-glow-cf26nra/comfort-glow-cf26nra_owners-operation-and-installation-manual_2486302021.webp)
www.desatech.com
113897-01A
21
OPERATING FIREPLACE
Continued
10. Wait one minute and switch selector switch
to the ON position to light burner.
11. Set flame adjustment knob to any level
between HI and LO.
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
WARNING: Make sure the
selector switch is in the OFF
position when you are away from
home for long periods of time.
Heater will come on automati-
cally with selector switch in the
ON position.
Figure 35 - Pilot
Ignitor
Electrode
Pilot Burner
Pilot Burner
Propane/LP
Natural Gas
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Heater
1. Turn control knob clockwise
to the
OFF position.
2a. Set selector switch in the OFF position
2b. If Using Optional Hand-Held Remote: Set
selector switch in the OFF position to keep
from draining battery.
Shutting Off Burner Only (pilot stays lit)
You may shut off the burner and keep the pilot
lit by doing one of the following:
1. Turn control knob clockwise
to the
PILOT position.
2. Use remote control manual OFF button.
3. Set selector switch in the OFF position.
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 6 under
Lighting
Instructions,
page 20.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow steps 9 through
11 under
Lighting Instructions,
page 20.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note:
All remote control accessories must be
purchased separately (see
Accessories,
pages
35). Follow instructions included with the re-
mote control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See
Lighting
Instructions
on page 20.
After lighting, let pilot flame burn for about one
minute. Turn control knob to ON position. Adjust
flame adjustment knob anywhere between HI and
LO. Slide the selector switch to the REMOTE
position (see Figure 36).
Note:
The burner may
light if hand-held remote was on when selector
switch was last turned off. You can now turn the
burner on and off with the hand-held remote
control unit.
IMPORTANT:
Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
Figure 36 - Setting the Selector Switch,
Control Knob, and Flame Adjustment
Knob for Remote Operation
Selector Switch in Remote Position
(Optional Remote Control)
ON
OFF
REMOTE
O
FF
PILOT
O
N
L O
IH
Control Knob
in On Position
Flame
Adjustment Knob