![background image](http://html1.mh-extra.com/html/desa/comfort-glow-ccl3930nt/comfort-glow-ccl3930nt_owners-operation-and-installation-manual_2485789014.webp)
14
104385
UNVENTED NATURAL GAS LOG HEATER
CGS2718N, CGS3124N, CLD3018N,
CLD3924NT, and CCL3930NT(A)
INSTALLING LOGS ON
MODELS CLD3018N AND
CLD3924NT
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify
logs. Only use logs supplied with heater.
INSTALLATION
Continued
Figure 19 - Installing Middle Log (#1)
Middle Log (#1)
Tab
Burner
“U” Bend
U-Shaped
Slot
Hole in
Grate Base
Back Log (#2)
Peg
Burner
Figure 20 - Installing Back Log (#2)
Crossover Log (#4)
Recess
Peg
Figure 22 - Installing Crossover Log (#4)
Front Log (#3)
Notches
Grate Fingers
Figure 21 - Installing Front Log (#3)
CAUTION: After installation
and periodically thereafter, check
to ensure that no flame comes in
contact with any log. With the
heater set to High, check to see if
flames contact any log. If so, re-
position logs according to the
log installation instructions in this
manual. Flames contacting logs
will create soot.
1.
Place the base of the middle log (#1) in
the U-shaped slots of the grate base.
The cutout on the right of the middle
log should fit over the burner (see Fig-
ure 19). Make sure the front of the
middle log is resting on the tabs of the
grate base and the cutout area is cen-
tered over the burner “U” bend.
2.
Locate pegs on the bottom of back log
(#2). Slide these pegs into the holes in
the grate base behind the burner (see
Figure 20).
3.
Locate the notches in the bottom of the
front log (#3). Place the front log on
the grate fingers. Make sure the notches
of the front log line up with the grate
fingers (see Figure 21).
4.
Place crossover log (#4) onto the pin
(right) on back log (#2) and into the
recess of the middle log (#1) (see Fig-
ure 22).
5.
Add lava rock around base of heater.
Do not place any lava rock on logs or
burner.