www.desatech.com
901918-01J
7
Figure 2 - Required Clearances for Chimenea
INSTALLATION
Continued
Items Needed for Assembly and
Installation
Before installing chimenea, make sure you have
the items listed below.
• piping (check local codes)
• sealant (resistant to propane/LP gas)
• equipment shutoff valve
• test gauge connection
• adjustable (crescent) wrench or pliers
• sediment trap (if required)
• tee joint
• pipe wrench
• Phillips screwdriver
• hammer
INSTALL CHIMENEA BASE
1. Set iron base stand in proper location. With
a helper, lift chimenea base and place onto
iron stand. Be sure notch around base rests
inside entire ring on stand and clamp fixture
is pointing towards rear of chimenea.
2. Tighten 3/8" bolt and nut combination on
adjustable stand until ring is snug on base.
Do not overtighten.
