![background image](http://html1.mh-extra.com/html/desa/cge3924nr/cge3924nr_owners-operation-and-installation-manual_2485768018.webp)
www.desatech.com
119638-01C
18
INSTALLATION
Continued
Figure 21 - Connecting Wires
Control.
Valve
White.Wire.
From.Receiver
Red.Wire.From.
Receiver
Figure 20 - Installing Remote Receiver
Push.
Button.
Clips
Bracket
Battery.
Clip
9-Volt.
Battery
Terminal.
Wires
Pad
INSTALLING BATTERIES FOR REMOTE
RECEIVER AND HAND HELD REMOTE
CONTROL
Two 9-volt alkaline batteries (not included)
are required to operate this heater with the
wireless hand-held remote control set. One
battery.must.be.installed.in.the.receiver.and.
one.in.the.hand-held.remote.control.unit.
Note: Only use alkaline batteries.
Installing 9-Volt Battery in Receiver
1.. Locate.back.of.receiver.behind.receiver.
bracket.mounted.on.base.assembly.
... Locate. the. battery. clip. mounted. on. the.
back.of.the.receiver.(see.Figure.0).
3.. Slide.a.9-volt.battery.through.the.clip.
4. Attach the terminal wires to the battery.
5. Remove heater base from fireplace.
6. Install receiver bracket to base with phil-
lips screws provided in hardware kit as
shown in Figure 18.
7. Disconnect jumper wire from control valve at
TPTH.and.TH.locations.(see.Figure.19).
8.. Install. remote. receiver. into. receiver.
bracket.using.pads.and.push.button.clips.
provided with receiver (see Figure 20).
9. Connect wires to control valve at the
TPTH and TH locations as shown in
Figure.1.
.
Note: Make sure excess wire does not
interfere with burner or pilot.
10..If heater was removed from fireplace be-
fore installation of remote accessory, see
Installing Heater Base Assembly
.on.page.
14 to reinstall heater into fireplace. Test gas
connection. for. leaks. (see.
Checking Gas
Connections
, page 16).
11. If logs were removed from heater for in-
stall remote accessory, replace logs (see
Installing Logs,
page.19).
Figure 19 - Disconnecting Jumper Wire
from Control Valve
Jumper.
Wire
Control.
Valve
Figure 18 - Installing Remote Receiver
Bracket
Remote.
Receiver.
Bracket
Phillips.
Screws