www.desatech.com
120069-01A
7
FINIShINg
Combustible Finishing Material:
Materials
made of or surfaced with wood, compressed paper,
plant fibers, plastics or any material capable of
igniting and burning, whether flame proofed or not,
plastered or unplastered (this includes drywall).
Noncombustible Finishing Material :
Mate-
rials which will not ignite and burn. Such materials
are those consisting entirely of steel, iron, brick,
tile, concrete, slate, glass or plasters or combina-
tions thereof or have a fire rating of zero.
WARNING: Grills on this heater
cannot, in any way, be covered as
it may create a fire hazard.
FINISHING CHECKLIST
• Power supply service must be completed prior
to finishing to avoid reconstruction.
• Grills and air openings cannot be covered in
any circumstances.
Note:
The heater is a zero clearance fireplace and
may be finished with combustible or noncombus
-
tible finishing materials.
When using paint or lacquer to finish the mantel, they
must be heat resistant to prevent discoloration.
OPERATINg
INSTRUCTIONS
The controls (see Figure 5) are located behind
the hinged top panel. Pull gently on top panel
to open.
Figure 5 - Controls For Electric Fireplace
1. Plug in your electric fireplace.
2.
Main ON/OFF power Switch and LED:
This switch is located on the right side of
the control panel. The power LED will
light up when the unit is on (see Figure 5).
When unit is on, the default settings for the
fireplace is low background lighting and
high ember bed and flame and the heater
is off.
3.
Temperature Control Button and LED:
This button is located to the right of the
Remote Control Receiver (see Figure 5). The
LED is located to the right of the Flame But-
ton. Push button to cycle through settings.
When this button is pushed the LED will
come on. When heater is on heat will emit
through vents located in the middle of the
top louver panel (see Figure 2, page 3).
The heater has a built-in thermostat so
it will shut off automatically once the set
temperature is reached. It will also turn
on automatically if the room temperature
drops below the set temperature.
Note:
When the heater is turned on for the
first time, it may release a slight, harmless
odor. This odor is a normal occurrence caused
by the initial heating of the internal heating
elements and should not occur again after
initial burn off. (This odor may occur again
if dust or debris has been trapped.)
4.
Flame Control Button:
This button is
located to the right of the Temperature
Button (see Figure 5). After power is on,
push the Flame Control Button to adjust
flame and ember bed brightness. Press and
release the Flame Control Button to cycle
through LO, MED, HI and OFF.
OpERATING By REMOTE CONTROL
1. Plug in your electric fireplace.
2. Push the ON/OFF Power Button to turn
unit on. Power LED will light.
3. When operating the remote control, it must
be pointed at the sensor on the bottom
panel.
Note:
Make sure your batteries are
fully charged and installed correctly in your
remote control.
4. The ON/OFF button at the top left of the
remote is the main ON/OFF power button.
Pressing this button activates the power to
the unit.
5. To adjust the ember bed lighting and flame
brightness, press the "-" or "+" FLAME
buttons . There are four levels of brightness.
FL
ON/OFF
Power
Button
Receiver
Flame Control
Power
Heater
Temperature
