Diamond Shield Crystal
Instruction Manual
Page 17
Menu „Settings“
This menu is used to configure the device. The settings made here
are retained even after turning off or changing the battery.
Language
: Select from English or German. The input is
done with the arrow keys left and right.
Contrast
: Adjusts the contrast of the LCD display. The input
is done with the arrow keys left and right.
Time:
The current time is displayed. To set the time, press
the OK button. The clock is stopped and the arrow keys left
and right change the hours.
By pressing the OK button you switch to the minutes. The
arrow keys left and right change the minutes now.
Pressing the OK button will change to the seconds.
In order to take over the adjusted time, move to a different
configuration entry by means of the arrow keys up or down.
Please also note the instructions in section
Changing the
battery
.
AutoStart1 and AutoStart2:
This shows whether the auto-
start of a program is active at a configured time. By pressing
the OK button you switch to the screen which provides the
appropriate configuration. See chapter Configuring the Auto-
Start function
Const amps:
enables or disables constant current control. If
you press the left and right arrow then the input is done. If
'NO
' is selected, the intensity of all the frequency programs
(including those that are stored on the chip cards) is usually
set on the voltage and does not have a constant current
control.
Speaker:
the tone pitch of the internal speaker. Use the
arrow keys left and right to choose 4 or 5 kHz.
HW Rev.:
Displays the hardware version of the device.