Diamond Shield Crystal
Instruction Manual
Page 14
Main Menu
A few seconds after switching on the device, the main menu will be
displayed. You can always go back to the main menu by pressing the
EXIT button.
The Main Menu shows the following items:
Chip card:
This entry is only shown if a chip card is inserted.
It allows you to execute, the content of the chip card. To
make sure that the Chip Cards are identified by the device,
it’s recommended to insert the Chip Cards when the device
is turned off.
Standard:
Via this menu you can use the preinstalled
sequences and frequency programs.
Settings:
Via this menu point you conduct various settings.
„Standard“ menu
Under
Standard
you find the pre-installed frequency programs the
Diamond Shield Zapper Crystal is supplied with by default.
The first level of the menu shows the available sequences. When a
sequence is selected and the OK button is pressed, a list of the
frequency programs of the selected sequence will be shown.
Executing a sequence
Select the desired sequence with the + and - button. Then press the
Start button. All individual programs of this sequence will be
performed now.
The device first checks the electrical contact (see "Contact Control").
After that all the individual programs of the selected sequence are
executed successively.
Running a single program from a sequence
Select the desired sequence with the + and - button. Press the
OK
button. The individual programs of this sequence are displayed. Then
select the desired single program.