Derksen GoboTop+, Operating Instructions Manual

Page: 12 / 28

Wall or ceiling mount using power cord and plug
1. Before mounting GoboTopPlus, find the best position for image projection. Switch the system
on and arrange the projected image as accurately as possible.
2. Mark the position on the wall or ceiling.
3. Switch the system off and unplug the unit.
4. Detach the mounting plate from the housing. Pull the release and turn the housing counter
clockwise. +
5. Place the mounting plate exactly on the marking on the wall or ceiling and mark the screw
hole in the centre of the plate.
6. Put the mounting plate aside, drill the hole into the wall or ceiling and insert the wall anchor.
Always choose the most suitable mounting fixture for the type of wall or ceiling you are using!
The mounting plate is designed for lens head screws with a 4 – 5 mm diameter. Do not use
counter-sunk screws because the mounting plate may be damaged.
7. Slightly tighten the screw in the centre, so that the mounting plate can still be adjusted.
8. Place GoboTopPlus on the mounting plate. Turn the housing clockwise, until it noticeably
locks into place. Make sure, that the mounting plate is flush with the housing.
9. Switch GoboTopPlus on and arrange the projected image as accurately as possible.
10. Switch the system off again and unplug the unit.
11. Detach the housing from the mounting plate.
12. Tighten the screw by hand in order to attach the mounting plate to the wall or ceiling.
13. Place GoboTopPlus on the mounting plate. Turn the housing clockwise, until it noticeably
locks into place. Make sure that the mounting plate is flush with the housing.
14. Make sure that the system is mounted firmly and safely.
10