Installa�on
En
gl
is
h
PHOS indoor
23 / 52
5.
Use the four corner holes for fixed installa�on. Use the
two arc-shaped elongated holes to correct the align-
ment a�er moun�ng.
6.
Connect the protec�ve ground connector to the ter-
minal.
7.
Use the three countersunk screws to a�ach the device
base to the moun�ng plate.
1.
Remove the moun�ng plate.
2.
Loosen the strain relief.
3.
Remove the a�ached power cord.
4.
Ensure the mains voltage matches the input voltage of
the projector as specified in the technical specifica-
�ons (220 – 240 V AC, 50 / 60 Hz) and your supply
cable is connected to a protec�ve ground connector
via the corresponding contact on the terminal block.
5.
Use either the cable gland with strain relief or the
centre hole in the moun�ng plate to pass the cable
through.
4.2. Direct wiring
WARNING! Danger of electric shock!
An electric shock can cause serious injury or death.
▶
Only allow a qualified electrician to carry out electrical connec�ons.