Moun�ng
En
gli
sh
22 / 52
Derksen Lich�echnik
1.
Ensure that the device is voltage-free.
2.
Loosen and remove the three countersunk screws on
the side of the device base.
3.
Disconnect the moun�ng plate from the device base.
4.
Carefully disconnect the protec�ve ground connector,
which is a�ached to the moun�ng plate, from the ter-
minal.
(Note: This makes the corresponding terminal block
accessible which can be used for electrical connec�on
instead of using the already installed power cord. Cf.
4.2. Direct wiring)
4. Moun�ng and installa�on
•
Your new LED projector must be securely installed before you start using it. The moun�ng plate offers you a wide range
of op�ons. Any stable, flat surface is suitable, regardless of its orienta�on.
•
Ensure that the suppor�ng structure can handle this load. It must carry at least four �mes the expected load. Informa-
�on on how much your device weighs is provided in the technical specifica�ons.
•
Select the fastening materials based on the load, the nature of the support material, and the fire and building regula-
�ons.
4.1. Moun�ng the projector
WARNING! Danger of electric shock!
An electric shock can cause serious injury or death.
▶
Only open the device once the mains supply has been switched off.
