Deprag MICROMAT-E 320E19-0002, Operating Instruction Booklet

Page: 14 / 24

14
7 Change of bits
DANGER
Make sure to disconnect the Spindle from the power sup-
ply, prior to changing of bits. This will avoid that Spindle
starts unintentionally and creates an injury.
INFORMATION
The Screwdriver Spindle is equipped with a quick change chuck.
Use high-quality bits in accordance to the DIN-Norm 3126 only.
·
To remove or insert the bit, push the sleeve into the screwdriver.
·
Push the bit into the hex until it locks.
·
Let the sleeve snap back.
·
Drive A3 (3 mm).
Picture: Change of bits
sleeve
bit