17
10 How the Measuring Electronic ME6000 Works
the measuring electronic ME6000 is switched off, all parameters remain saved. It is
not necessary to input the same data twice.
Values can be changed as described in chapter
Software Description
10.1 General Function
If
.
10.2 General Measurement/Technical Information
The Transducer (measuring platform/Dynamometers) has to be positioned on a solid
base, without allowing any movement.
At that time the transducer should be free of external forces or vibrations (such as the
distortion of the measuring platform resulting from incorrect installation).
After each start-signal, the charge amplifier will reset and perform a zero calibration.
External forces, momentum, or vibration can distort the torque measurement.
In order to provide a high level of quality assurance and for you to be able to present the
respective documents in case of an audit, we recommend to have your measuring
devices re-calibrated once a year.
Concerning our torque measuring units and torque dynamometers as well as for a
complete measuring series we would like to offer you to have these calibrated at the
DEPRAG Amberg facilities.
IMPORTANT
Please do not hesitate to contact us in case you have questions.
DEPRAG SCHULZ GMBH u. CO.
Visit our home page
www.DEPRAG.com
.
10.3 Test of Tool Function Capability
Prior to the use of a tool for the mass production, it can be testes, if this tool fulfils the
required demands with sufficient safety margin.
The goal of a Function Capability Test is to proof that:
a)
the tool to be tested conforms to recognized regulations. If no regulations are
recognizable, then the tool does not have a defined capability. It is then not
acceptable to assign statistical calculated capability values to such a tool.
b)
the tool is capable to assemble parts within defined tolerances. The required proof
can only be established using the recognized regulations, as shown under a).
The function capability test is a short-term test, with the goal to obtain exclusive
machine-conditions that influence the manufacturing process.
