The Li-Po batteries may be recycled
Please discard old batteries in a proper recycling station.
Do not throw batteries in the regular trash. If you have questions,
please contact your local environmental agency to collect old batteries.
1. Charge the Battery
2. Warnings
Connect the Li-Po battery to USB before plugging the USB to power or your
computer. One end of the USB charger goes into any free port on your computer
The other end plugs into your battery. You may leave the battery in your copter, or
remove it for external charging. While charging, the light will be on solid red. When
charging is complete, the light will blink. The recharge time should be around 120
minutes.When the battery runs low, the transmitter will activated a “di, di” sound
alarm, and the LED lights on the quadcopter will flash. This indicates that the battery
has only a short time left, so fly the drone back immediately for retrieval.
1. The blade guards are removable. To install each blade guard, press the square area
at the bottom of the guard against the matching section of the drone. Use the
supplied screws to attach each of the 4 guards.
2. Keep the guards installed to protect the drone and users, or remove the guards for
lighter weight and more speed and maneuverability. Note that the blades (propellers)
are easy to replace, but each blade is different. If the incorrect rotation-style of blade
is used, the quadcopter will not fly.
CHARGING LI-PO BATTERY
ENG-5
ENG-6
This product is equipped with a Li-Po battery. Please take note of appropriate safety
precautions when not in use.
Do not expose the charged battery to high temperatures, such as flames or near
electronic devices. This may cause damage or explosion.
Make sure all batteries are connected in the proper orientation to avoid damage or
explosion.
Do not use the battery to impact any hard surfaces. Avoid contact with metal.
If the battery becomes damaged, bulges, or appears to change shape, please stop
using the battery and discard it.
When charging the battery, to avoid accident, put the power supply on the ground.
Avoid setting the charger on cloth or other flammable materials becausethe charger
will get hot.
Do not immerse the battery in water. The battery should be kept in a dry place.
Do not break the battery or attempt to open the battery.
Do not leave the battery charging without supervision.
When the battery is not being used for a long time, remove it and put it in a safe dry
place.
*
*
*
*
*
*
*
*
*
*
* For safety, make sure the switch beneath the drone is in the OFF position before
you electrically connect the battery cables. Connect the battery to the
drone by gently plugging the cable on the battery to the power cable
underneath the drone. Make the sure receptacles are oriented correctly so that
one receptacle slides smoothly into the other.
* To disconnect the battery, grasp the plastic receptacles with your fingers. Never
pull the cables apart by pulling on the cables.
Connect Battery
* Install the Li-Po battery in the drone,
press the tab at the front of the battery compartment
down to access the battery compartment, and insert
the battery base-first into the compartment so that
the cable on the battery is exposed.
* To remove the Li-Po battery from the drone, press
down on the tab with one hand and grasp the
battery with your other hand to pull the battery out
by its sides (never pull the battery out by its cables).
To assemble the Controller, install 4 1.5V AA
batteries (not included) in the controller/ transmitter.
You may need a small screwdriver to open and
then close the cover over the battery compartment.
FLIGHT PREPARATION
Press Down on
Tab to Access
Battery Compartment
Lithium battery inside!
Do not try to open the product!
Do not expose to heat, water,
moisture, direct sunlight!
Warning
CAUTION!
3. Connect the Battery
2. Install Li-Po Battery in DCH-600
1. Install 4 AA Batteries in Controller
