Getting Started
Before using the generator, always do a visual pre-start inspection of the entire generator assembly for
any obvious signs of damage, leaks, loose or missing parts. Check all fluid levels and add as necessary.
Also, refer to the drive unit manufacturer’s (Honda, Yanmar, Baldor or other) manual for any specific
pre-start inspection procedure.
If there is noticeable damage, do not use the generator. Repair
damage before using the generator.
Before using any power tool always inspect the power cord, including any extension cords, for bare
wires, cuts or bulges and that both the cord and plug are in good and useable condition with no damage,
including missing ground prongs. After proper grounding of the generator has been achieved, connect
the tool to the generator by inserting the plug into the receptacle. Next, check to make sure that the
Start/Stop (on/off) switch for the tool is in the Stop (off) position. Start the engine or motor (HCMG-
180-1 and HCMG-180-3 units only) according to the manufactures instructions (see manufacturer’s
manual for the proper start-up procedure).
6
