9
7 3 Electrical Requirements
Incoming power to the system must be 100 volts AC to
•
240 volts AC, single phase 50/60 Hz capable of
supplying 1.0 amps.
The system power should be supplied through the AC
•
power cord provided with your system.
7 4 unpacking the System
Carefully unpack your Cavitron
®
JET Plus Combination System
and verify that all components and accessories are included:
1. Cavitron
®
JET Plus Combination System with
Handpiece Cable Assembly with swivel
2. Air Line Assembly (Black) with Filter and Quick
Disconnect
3. Water Line Assembly (Blue) with Filter and Quick
Disconnect
4. Additional Water Line Filter
5. Detachable AC Power Cord (not shown)
6. Cavitron
®
Tap-On
TM
Wireless Foot Pedal
7. “AA” Batteries (4-Pack)
8. Auxiliary Cable for Tap-On
TM
Foot Pedal
9. Cavitron
®
JET Air Polishing Insert with cleaning tool
10. JET-Mate Detachable Sterilizable Handpiece
11. Prophy Handpiece Cleaning Wire (not shown)
12. Cavitron
®
Ultrasonic Inserts (quantity optional)
13. Efficiency Indicator for Cavitron Inserts
14. Literature Packet
15. PROPHY-JET
®
Sodium Bicarbonate Prophy Powder
16. JET-Fresh
®
Aluminum Trihydroxide Prophy Powder
(may not be included in all kits)
17. Powder Removal Container
7 5 System installation
The Cavitron
•
®
JET Plus Combination System is designed
to rest on a level surface. Be sure unit is stable and
resting on four feet.
Placing unit in direct sunlight may discolor plastic
•
housing.
The system has been equipped with a Cavitron
•
®
Tap-On
TM
Wireless Foot Pedal which was factory synchronized
to operate with the system’s base unit. If your office
has more than one Cavitron
®
JET Plus system, it is
recommended that you mark the
Tap-On
TM
Foot Pedal
and base unit for easy reference as to which Tap-On
TM
Foot Pedal operates with which base unit. Should
resynchronization be necessary, follow the instructions in
Section 7.10.
7 6 Power Cord Connection
Verify the Main Power ON/OFF switch, located at the
•
center front underside of the System, is set to the OFF
(O) position before proceeding.
Insert the AC power cord into the power input on the
•
back of the System.
Insert the pronged plug into an AC wall outlet.
•
7 7 water Supply Line Connection
Grasp the Water Supply Line (blue hose) by the end
•
opposite the quick-disconnect and insert it into the water
inlet connector until fully seated.
Connect the quick-disconnect to the dental office water
•
supply or a Cavitron DualSelect Dispensing System.
Inspect all connections to make certain there are no
•
leaks.
To remove the water line from the Cavitron
•
®
JET Plus
Combination System, turn off the dental office water
supply. Disconnect the water supply line from the dental
office water supply. If a quick-disconnect connector is
attached to the end of the hose, relieve the water
