DENT Instruments PowerScout 12 HD, Operator'S Manual

Page: 67 / 94

68
DENT Instruments
PowerScout HD
RTU Programming & Scripting
2 Wire 1 ɸ ( Plug Load)
Service Type 3
V_Input 1 or 2
Description 31 Char
Channels Volt Ref CT Type Range Phase Shift CT Multiplier CT Sign
CH1 ANY [1-6] mV [1] or RōCoil [2] Any > 0A -4.0 ˚ to +4.0 ˚ Any > 0 [1] 0 or 1
CH2 ANY [1-6] mV [1] or RōCoil [2] Any > 0A -4.0 ˚ to +4.0 ˚ Any > 0 [1] 0 or 1
CH3 ANY [1-6] mV [1] or RōCo il [2] Any > 0A -4.0 ˚ to +4.0 ˚ Any > 0 [1] 0 or 1
Any channel that needs to be turned OFF should set the CT Type to OFF [0].
3 Wire 1 ɸ (Split Phase)
Service Type 4
V_Input 1 or 2
Description 31 Char
Channels Volt Ref CT Type Range Phase Shift CT Multiplier CT Sign
CH1 L1 – N [1] mV [1] or RōCoil [2] Any > 0A -4.0 ˚ to +4.0 ˚ Any > 0 [1] 0 or 1
CH2 L2 – N [2] mV [1] or RōCoil [2] Any > 0A -4.0 ˚ to +4.0 ˚ Any > 0 [1] 0 or 1
CH3 L3 – N [3] OFF [0] Any > 0A -4.0 ˚ to +4.0 ˚ Any > 0 [1] 0 or 1
Even though CH3 is not used for computation it is recommended that the CT settings reflect those from CH1 rather than being left at factory
default to facilitate configuration validation from the RTU.
Disabled (OFF)
Service Type 5
V_Input 1 or 2
Description 31 Char
Channels Volt Ref CT Type Range Phase Shift CT Multiplier CT Sign
CH1 L1 – N [1] OFF [0] Any > 0A -4.0 ˚ to +4.0 ˚ Any > 0 [1] 0 or 1
CH2 L2 – N [2] OFF [0] Any > 0A -4.0 ˚ to +4.0 ˚ Any > 0 [1] 0 or 1
CH3 L3 – N [3] OFF [0] Any > 0A -4.0 ˚ to +4.0 ˚ Any > 0 [1] 0 or 1
Even though disabled channels are not used in calculations and report 0.0 they still contain configuration information. It is suggested that they
be set to a known value rather than left at defaults to facilitate configuration validation by the RTU.
www. .com
information@itm.com 1.800.561.8187