Attention
:
LNB Power: Single mode
: keep the status on “
on
”
Loop situation
: keep the status of the machine
which connected the
satellite signal on the “
on
”
and others on the “
off
”
Press the
EXIT
key to return to the
FAST SCAN
interface
After setting the LNB parameter, move the cursor onto the
instruction [Start Scan], press the key [OK] to commence the
process of scanning. After the process, the machine will save
all the scanned channel and return the interface to the
program-enjoying's
ADVANCED INSTALLATION
Light the [Advanced Installation] tape and force down the
OK key
to enter. Before entry needs code
Antenna Settin
g: refer to the above-mentioned
Channel Scan
: light the second tape [Channel Scan], press
the key [OK] to enter
Light the first instruction; press the </> key to
choose one the satellite or press the
OK
key to display the satellite bar to pick
If the type of the
DiSEqC
in the
ANTENNA SETTING
is
set on motor, then the instruction
Motor
Position
owns the
selectivity. Press the </> key to set
=>E
: to drive the dish eastwards
=>W
: to drive the dish westwards
light the
Scan Type
, In which:
ALL, FTA,
Scrambled:
ALL
: to scan all the channels in the selecting satellite
FTA
: to scan the channels, which belong to the [Free To Air]
Scrambled
: to scan the scrambled channel
NIT Search
: to scan the channels, which are, belong to the
network
Light the
Scan Mode:
Sat:
to scan the channels in the selecting satellite
TP:
to scan the channels on the present
TP
Manual:
to scan the channel by operator
Finish all the above operation; it is time to scan the channels,
if the scan is rescan on
Sat
, there will appear a
“
warning
” dialog box:
YES
, to rescan;
NO
, to cancel
The scanning interface shows us as next page
10
