© by DENQBAR GmbH
http://www.denqbar.com
58
Use of continuous current (DC)
1. Turn on the device and check that the operating display lights up.
2. Ensure that the desired consumer is turned off and only then connect the cable of the
consumer with the DC-socket.
NOTICE!
In DC operation (DC), turn the switch of the fuel economy mode into position "OFF".
Overload protection
230 V-socket:
the operating display lights up at normal operation
in case of overload it will be indicated by the command
OVER
in the field
P
of the operating
display
in case of overload turn the ignition key into position "STOP" and remove connected devices
afterwards restart the generator
Attention!
If this happens, reduce the electric power you are taking from the generator or remove any
defective connected appliances.
Overload or malfunction of the consumers
Attention!
Inductive consumers require more power for start-up. So ensure that you don’t exceed the
rated power with the consumer you use.
12 V DC connector
If an overload occurs, the 12 V DC connector will be isolated from the supply. The 12 V DC connector
can be reconnected by pressing the overload switch (DC-Reset).
Attention!
The 12 V DC socket can only be charged with 60 W max.
Operating display
AC-power outlet
