Getting Started
Connections and Settings
Operations
Troubleshooting
ENGLISH
Settings and Connections
SPEAKERS
XLR
RCA
SPEAKERS
XLR
RCA
SPEAKERS
XLR
RCA
SPEAKERS
XLR
RCA
SPEAKERS
XLR
RCA
w
q
w
q
"6%*0
065
13&
13&
065
NOTE
• The same signal is output to speakers A and B.
• Please use the following speaker impedance.
· When using only speaker A or B ·····························4 ~ 16 Ω
/ohms
· When using speakers A and B at the same time ····8 ~ 16 Ω
/ohms
Normal Connections
Example: Normal connection to the
channel
b
Setup each channel (
~
,
~
) using the same steps.
Connection for signal input to each channel to be output from the channel’s speaker terminal.
• Set each switch as shown below.
q
Set the
Operation mode select switch
to “NORMAL” (
v
page 6).
w
Set the
Input select switch
according to the input (
v
page 6).
· For RCA input ······ Set to “RCA”.
· For XLR input ······· Set to “XLR”.
Set the rear panel
“Operation mode select switch”
and
“Input select switch”
according to the
connection method.
NOTE
The
Operation mode select switch
and
Input select switch
must be set before turning the power on.
Settings which are changed after powering on will not be registered. In such cases, the power should be
switched off and on again.
SPEAKER A
SPEAKER B
Connections and Settings
Input select switch
Operation mode select switch
Bi-wiring connection
When using speakers that have input terminals for both woofer units and tweeter units, this connection
allows for the same signal to be output from each unit.
With this connection the interference between signals for the woofer unit and tweeter unit is low so that
you can enjoy high quality sound in playback.
SPEAKERS
XLR
RCA
SPEAKERS
XLR
RCA
SPEAKERS
XLR
RCA
SPEAKERS
XLR
RCA
SPEAKERS
XLR
RCA
HIGH
LOW
w
q
w
q
"6%*0
065
13&
13&
065
Input select switch
Operation mode select switch
NOTE
When using Bi-Wiring connection use 4 ~ 16 Ω/ohms speakers for the impedance.
1.POA-A1HDE2_ENG.indd 13
2008/01/18 11:34:44