7
Operation
Bluetooth Pairing
You can play audio from an audio device that sends its signal over a Bluetooth connection (e.g.,
smartphones, tablet computers, etc.). DN-333XAB has a range of up to 100 feet (30.5 meters).
Once you “pair” your Bluetooth device with DN-333XAB, they are “connected” wirelessly. You can
play audio on your Bluetooth device, and it will be sent out of DN-333XAB’s
outputs
.
Important:
•
DN-333XAB will not receive audio from a phone call. While using it, we recommend disabling
your cellular connection, if possible.
•
Do not use DN-333XAB near a microwave oven, which can interfere with the reception.
•
While DN-333XAB is paired with a Bluetooth device, other Bluetooth devices cannot pair to it.
You must unpair (“disconnect”) the current Bluetooth device from DN-333XAB to make it
available to others.
To pair your Bluetooth device to DN-333XAB:
1.
If DN-333XAB is off, use the included
power cable
to connect its
power input
to your power
source.
2.
Make sure your desired Bluetooth device has its Bluetooth connectivity on and is within range.
DN-333XAB will automatically try to pair with the last-paired Bluetooth device, if any.
If you are using that Bluetooth device again, you can start playing audio immediately.
If you want to use a different Bluetooth device, continue to
Step 3
.
3.
Press and hold DN-333XAB’s
BT
Pair
button for
3
seconds. When the
Bluetooth
Light
starts
flashing quickly, release the
BT
Pair
button.
4.
On your Bluetooth device, enter its Bluetooth settings menu, and select
DN-333XAB
.
Note:
(Some older Bluetooth devices may require you to enter a PIN. If this is the case, enter
0000
as the PIN.)
5.
On your Bluetooth device, start playing audio.
To adjust your volume level, we recommend setting the volume control of each of your devices
in the following order:
i.
your Bluetooth device
ii.
DN-333XAB, using its
BT/AUX IN Level
knob
iii.
DN-333XAB, using its
Speaker Level
knob
iv.
your mixer, if any (its input channel level[s], then its main output level)
v.
your loudspeakers
Set each volume level as high as possible without creating distortion or any “clipping” of the
sound.
Important:
DN-333XAB will not receive audio from a phone call. While using it, we recommend
disabling your cellular connection, if possible.
To unpair your Bluetooth device from DN-333XAB,
do one of the following:
•
Enter your Bluetooth device’s Bluetooth settings menu, and disconnect from
DN-333XAB
.
•
Or alternatively, press and hold DN-333XAB’s
Pair
button for
3
seconds, and then release it.
DN-333XAB will unpair from your Bluetooth device and be available to pair to another one.
