10
Premier SP20005_REV_2
As an indication coins measure the following:-
- 1p 1.58mm (0.063” )
- 2p 1.80mm (0.071” )
- 5p 1.73mm (0.067” )
- 10p 1.84mm (0.072” )
- 50p 1.84mm (0.072” )
- £1.00 3.14mm (0.124” )
Remember height of cut is effected by moisture of turf , weight of machine and the
thatch density. Different makes of machine cut at different heights when set to the
same position with the setting bar. We suggest you set it to a couple of mm above your
planned height and then come down in height by trial.
If on setting the height of operation you find it needs altering once on the green simply
click the adjusters up or down the same on each side until the desired height of
operation is achieved.
Always check height of cut/operation with the setting bar provided. Check in two
positions i.e. one at either end of the cassette. Failure to do this could result in an
uneven cut.
General Adjustments
SETTING FOR HEIGHT OF CUT
Always stop the engine before adjusting the height of
cut. Failure to do this may result in serious injury.
The length of grass after cutting and the depth of
scarification / dethatching / brushing, depends on the
setting of the front roller in relation to the main frame
of the machine.
To set:
• Slacken the clamp nuts on the front roller quadrants (Item 1) [19mm spammer].
• Rotate the quadrants, raising and lowering the machine. As a guide, there are notches in the quadrant and holes in the
side plate. Align these on both sides to level the machine.
To check the height of cut and that the machine is level a setting bar (229524) can be used. Place the bar between the
front and rear rollers, resting the underside of the bolt head on the lip of the shear blade.
560
Item 1
