10
General Adjustments
SETTING THE CYLINDER
The Cylinder can be set either in or out of the machine.
To Set:
•
Slacken 2-off lock nuts (Item 1) [19mm spanner]
•
Rotate nut (Item 2) anti-clockwise to bring the blade
towards the cylinder.
•
Check the setting using thin paper along the length
of the cylinder.
•
Adjust until it cuts across the whole length.
•
When set, tighten the lock nut (Item 1)
•
Recheck adjustment.
•
DO NOT set the cylinder hard to the bottom blade.
This will cause excessive wear of both components
and increase fuel consumption.
Item 1
HANDLEBAR ADJUSTMENT
The “Handle Bars” are adjustable to achieve the
correct working height for the operator.
To Set:
•
Slacken off 4-off nuts (Item 1) ¼” turn [17mm
spanner]
•
Raise / lower the “Handle Bar” to the desired
position.
•
When set, tighten the nuts (Item 1)
Item 1
Item 2
SP20038_REV0
OCTOBER 2017
