4.1
User Menu
The
USER MENU
is straightforward, with all the choices offered on just two screens.
When called, the screen will display the following options, against a camera display
background, with a cursor at the left hand edge:
Go to Position
Start Sequence
Start Queue
Technicians Menu
Supervisors Menu
Exit
This menu allows the operator to recall the full range of stored Positions, Sequences,
and Queues even if the control panel has neither the numerical range nor general ability
to do so, but the menu does not allow any initial programming.
The required choice is made by positioning the cursor using the joystick or pan & tilt
direction buttons, then pressing the ACCEPT button(s) on the control panel; if Exit is
chosen the menu is cleared and no other action is taken by the dome.
The display will otherwise prompt for the required numerical entry with the following
subsidiary menu:
Position Number _ _ _
(or Sequence, or Queue)
0 1 2 3 4 5 6 7 8 9
Accept Entry
Clear Entry
Cancel
The cursor is run across the numerical line, using the joystick or control buttons, until
the desired number is reached. The characters will flash their position in turn and as
soon as one is selected with the ACCEPT button(s) it will be displayed in the _ _ _ part
of the display.
Leading zeros need not be entered (eg 001 may be entered 1), but the entry must be
within range, eg 001 - 250 for Positions, 001 - 100 for Sequences, and 01 - 50 for
Queues. Entries outside the range will cause an ‘Illegal Entry; message to flash, and the
entry must be cleared and re-entered.
When all three digits have been selected, Accept Entry will invoke that choice and the
screen will automatically clear to the camera signal.
To change the choice ‘Clear Entry’ will start the process again
2055
Menu System Manual
Sheet.7
