![Denios bio.x T700 User Manual Download Page 9](http://html1.mh-extra.com/html/denios/bio-x-t700/bio-x-t700_user-manual_2480166009.webp)
User Manual
bio.x T700 160416
Page 9 of 15
Issued 10/2010
6.1 Energy-saving mode
The unit can be switched to energy-saving mode during downtimes such as night-time, weekends, or company
holidays as long as you like.
The temperature is maintained at 30º C in energy-saving mode. The micro-organisms remain active at this
temperature and optimum oil and grease degradation is guaranteed.
Settings:
1) Press the multi-function button for > 3
s
A 2-digit number appears in the display (time period for
the energy-saving mode, last set value),
the first digit is flashing.
2) Press the multi-function button for a
short time
The flashing digit will count up (0 will follow after 9)
3) Press the multi-function button for > 2
s
The 2nd digit flashes
4) Press the multi-function button for a
short time
The flashing digit will count up (0 will follow after 9)
5) Press the multi-function button for > 2
s
The set time is displayed alternately with the „30“ for the
energy saving mode.
The display of the hours refers to the remaining time
until the unit is switched on again
(hour or part thereof)
If the operator does not set any time, the displayed value will be taken over automatically after 10 s. If the
value"00" is set, the time control function is not used and the energy-saving mode must be terminated by pressing
the multi-function button for a short time.
After the energy-saving mode has been terminated, the unit heats the cleaning fluid up to 41 °C. The warm-up
stage takes about an hour, depending on the ambient temperature. Once this temperature is reached and "41" is
shown continuously on the display, the unit is ready for operation with optimum cleaning assured.
6.2 Controllable pump run time
(Control unit # 190379 with software version V1.12 and later)
The pump run time can be preselected with fixed values. This is reasonable for automatic cleaning, e.g. when the
optional immersion basket set or the spray unit is used.
For this purpose, 5, 10, 15 or 60 (basic setting) minutes are available. During the reduced pump run time (5, 10,
15 minutes), the remaining run time is displayed in minutes.
Settings:
1) Press the multi-function button for a
long time > 10 s
If the set pump run time is reached, number „05“ will be
displayed.
(After 3 s, ‘00’ is displayed while the first digit is flashing
– continue to press and hold the multifunction button)
2) Press the multi-function button for a
short time
Set the pump run time in the steps of 5, 10, 15 60
minutes
3) Press the multi-function button for
for > 2 s
The setting will be accepted
The set pump run time is then used for the following cleaning processes. The pump is automatically switched off
after the time period has passed.
After the unit has been switched off (pulling of the plug) or after power failure, the basic setting of 60 minutes will
be active again.