CAIR
plus
Assembly
PR-2009-0096-GB • Subject to modifications • R8-10/2015
33
5.2.3 Additional measures for units for outdoor installation
•
After assembly is completed, you must remove the protective foil from the roof
panels.
5.2.4 Preparing roof installation
•
Remove all lifting lugs (1).
•
Install sealing washers at all screws and tighten them (2).
Fig. 5-25: Preparing roof installation
ATTENTION
Risk of damage to the unit!
9
Insufficient or improper sealing by others on site can cause water leakage and
damage to the equipment and building materials!
•
Carefully seal all unit components.
•
When installing roof components ensure that no loads are applied on the roof
panels. Do not walk on the floor panels.
•
If necessary use a proper pad for the entire roof surface.
•
During assembly and assembly pauses, take care that no rainwater gets into the
units.
1
1
1
2