1. Getting acquainted with your High Pressure Cleaner
HB-200 V00
Page 5
The high pressure cleaner is now ready for operation. The spray-gun lance will experience a
recoil force during operation – therefore keep a firm grip with both hands on the Spray-gun
handle and the lance. Press the trigger and start cleaning.
-
P
ressure can be regulated by adjusting the knob on the spray-gun lance.
-
W
hen using the chemical injector, pressure must be adjusted to low.
Make sure your local power supply specifications are in accordance with the
motors requirement. Refer to the ID-plate on the machine. Do Not run the High
Pressure Cleaner without sufficient potable water supply as it can cause
cavitation and serious damage to internal pump parts. Do not let the machine
recycle the water (running with Spray-gun trigger not activated) for more than
a few minutes as this can cause serious damage to the seals.
Starting up for the 1
st
time
1.
Allow water to flow within the machine for about 3 to 5 minutes without turning on the
machine to allow any dirt or air to be vented out from the delivery outlet.
2.
Ensure the mains voltage is the same as that of the machine printed on the technical data
plate.
Failure to comply with the regulations stated above, manufacturer declines all
responsibilities for the staff and provides no warranty.
Water Connection
1.
Connect the inlet hose to the water mains using the
High Pressure hose which comes together with the
machine.
(Max Pressure: 200Bar).
Filling up with Fuel
1.
Fill the tank with the Diesel.
2.
Avoid running the machine when diesel tank is empty in
order not to damage the fuel pump.
CAUTION
NOTE
