Demon Tempest 1, Instruction Manual, Page: 13 / 56

The Tempest Cabinet washer is simple to install, there are four holes in the feet for bolting to a solid sur ‐
face such as a concrete plinth and a 10 mm masonry drill can be drilled to a depth to suit either raw bolts
or sleeve anchors. The water supply is via a standard hose pipe to a tap and there is a stepped nipple to
suit 13 mm and 19 mm pipe.
Electricity supply must be wired by a competent electrician and we recommend the supply is wired using
armoured cable with an isolator nearby. If a separate supply is required for the frost protection system
then this must be installed upstream of the isolator so the heater will work even if the mains supply is
turned off. A fused spur is ideal for this application.
230V model – needs a D20 MCB on your distribution panel
415V model – needs a D20 triple MCB on your distribution panel
Both models – separate feed for frost protection 5 amp fused spur
Prolonged periods of cold weather
In prolonged periods of cold weather we advise turning the water off and running the machine until it is
empty then disconnect all hoses and isolate from the mains power but leaving the frost protection circuit
live to give some heat inside the cabinet.
Tempest Cabinet Washer ‐ Installation Instructions