7
selector button. The L-side of the selector
button is pushed to turn the bit counter-
clockwise.
CAUTION
When using the cordless drill follow
these rules:
• continuous use of the drill should not
exceed 15 minutes;
• do not allow mechanical damage
(strikes, falls etc.);
• protect the drill from external sources of
heat and chemically active substances, as
well as liquid and objects penetration;
• before disconnecting the tool from the
power source turn off the On/Off switch;
• check the engine temperature, do not
allow overheating;
• change the rotation direction only after
switching off the tool and complete stop
of rotating parts.
Inobservance of these rules will make
warranty void!
WARNING! Repair, modification
and check of ZENIT power tools should
be performed only in authorized service
centers ZENIT. While use or maintenance
of power tools follow all safety rules and
standards.
NOTE
Zenit Power Tools are constantly being
improved and modified to incorporate the
latest technological advancements.
Accordingly, some parts may be changed
without prior notice.
long period of time may cause screw
breakage due to excessive tightening.
3. Mounting and dismounting of the bit
• Mounting the bit
Loosen the sleeve by turning it toward
the left (in the counterclockwise direc-
tion as viewed from the front) to open the
clip on the keyless chuck. After inserting
a driver bit, etc., into the keyless drill
chuck, and tighten the sleeve by turning it
toward the right (in the clockwise direc-
tion as viewed from the front).
If the sleeve becomes loose during opera-
tion, tighten it further.
The tightening force becomes stronger
when the sleeve is tightened.
• Dismounting the bit. Loosen the sleeve
by turning it toward the left (in the coun-
terclockwise direction as viewed from the
front), and then take out the bit etc.
NOTE
If the sleeve is tightened in a state where
the clip of the keyless chuck is opened
to a maximum limit, a click noise may
occur. This is the noise that occurs when
the loosening of the keyless chuck is
prevented and is not a malfunction.
CAUTION
When it is no longer possible to loosen
the sleeve, use a vise or similar instru-
ment to secure the bit. Set the clutch
mode between 1 and 7 and then turn the
sleeve to the loose side (left side).
4. Confirm that the battery is mounted
correctly.
5.Check the rotational direction
The bit rotates clockwise (viewed from
the rear side) by pushing the R-side of the
