4
tool is used outdoors, use only extension
cords intended for outdoor use.
20. Stay alert. Watch what you are doing.
Use common sense. Do not operate tool
when you are tired.
21. To avoid possible danger always use
battery charger, specified for this model.
22. When power cord of battery charger is
damaged, have it replaced by authorized
service center. Repair should be per-
formed only by specialists of authorized
service center. Manufacturer doesn’t bear
responsibility for any failures or damage
resulting from improper use or unauthor-
ized repair.
23. Do not charge at voltage higher than
indicated on the nameplate.
24. Always charge batteries before use.
25. Never use inappropriate batteries. Do
not connect ordinary dry battery, battery
pack different from designated battery,
or automobile battery to power tool. Do
not use any transformers with additional
devices and rectifiers. Do not charge bat
-
tery from electric generator or DC power
source. Never charge outdoors. Keep the
battery away from direct sunlight and use
only where there is low humidity and good
ventilation.
26. Check damaged parts. Before further
use of the tool, a guard or other part that is
damaged should be carefully checked to
determine that it will operate properly and
perform its intended function. Check for
alignment of moving parts, free running of
moving parts, breakage of parts, mounting
and any other conditions that may affect
its operation. A guard or other part that is
damaged should be properly repaired or
replaced by an authorized service center
unless otherwise indicated in this instruc-
tion manual. Have defective switches
replaced by an authorized service center.
Do not use the tool if the switch does not
turn it on and off.
27. Warning Use only accessories or
attachments recommended in this instruc-
tion manual or in the catalogue of ZENIT
ТМ.
28. Have your tool repaired by a qualified
person. This electric tool is in accordance
with the relevant safety requirements.
Repairs should only be carried out by
qualified persons using original ZENIT
TM spare parts. Otherwise this may result
in considerable danger to the user.
safety precautions on usinG
cordless drill
1. Always charge under temperature 5°C-
40°C. Temperature below 5°C may lead to
overcharge, which is dangerous. Battery
cannot be charged at temperature above
40°C. The most favorable temperature for
charging is 20°C-25°C.
2. Once the charging has been completed,
give 15 minutes rest until the next charg-
ing. Never charge more than two batteries
in a row.
3. Never insert foreign objects into the
hole for the battery or the battery charger.
4. Never disassemble the battery and bat-
tery charger.
5. Never short-circuit the battery. Battery
short circuit may result in the risk of fire.
6. Never incinerate the battery. The battery
can explode.
7. Before drilling into walls, ceilings or
floors, ensure that there are no concealed
power cables inside.
8. In case after charging battery life
becomes too short for practical use, take
exhausted batteries to the shop, where
they were purchased, for disposal. Do not
dispose of the exhausted batteries. Using
exhausted battery may lead to battery
charger damage.
