DEMAG DRC-DR D2, Operating Instructions Manual

Page: 23 / 28

23
21495344.indd/31
1007
Precondition: Parameter code 003 activated
The default setting set in the factory is ”Hearbeat off”.
The current setting for the CAN function heartbeat is shown in the display. To
navigate, use the following keys:
DRC-10 DRC J Funktion
Right Display key → Change to display of parameter 004
Left Display key ← Change to display of parameter 002
Lift Display key ↑ Exit parameter programming menu
F1 F1 Change to entry mode
After changing to entry mode, the number sequence 000 for the ”Heartbeat off”
status appears in the display. The ”Heartbeat on” status is represented by number
sequence 001.
To select and to navigate, use the following keys:
DRC-10 DRC J Funktion
Right Display key → Display the next possible value
Left Display key ← Display the previous possible value
Lift Display key ↑ Exit entry mode
F2 F2 Accept the displayed setting
Precondition: Parameter code 004 activated
This sub-menu is used for entering the crane identification. When a radio receiver
is put into operation, it must be entered once via the radio transmitter.
Since the radio control permanently displays the crane identification in the upper
main row of the display, only number sequence 000 is shown in the second main
row.
To navigate, use the following keys:
DRC-10 DRC J Funktion
Right Display key → Change to display of parameter 005
Left Display key ← Change to display of parameter 003
Lift Display key ↑ Exit parameter programming menu
F1 F1 Change to entry mode
After changing to entry mode, the ”——” character sequence is shown in the dis-
play. Entry starts with the first character on the left.
In entry mode, the character required for the crane identification can be selected
from the available set of characters by scrolling. To scroll, use the following keys:
• DRC-10: Left and right keys
• DRC-J: Display keys ← and →
In addition to figures and letters, many special characters may also be used.
Attention:
If the same crane identification is entered for two radio receivers, the operator
can no longer distinguish the two cranes by the crane identification shown in the
display.
1.8 Changing the crane
identification
1.8.1 Display mode
1.8.2 Entry mode
1.8.3 Selection of characters
1.7 Switching on and off
the CAN heartbeat
function
1.7.1 Default setting
1.7.2 Display mode
1.7.3 Entry mode