20
21495344.indd/31
1007
The radio receiver parameter programming menu is used by specially trained
personnel for programming parameters of the radio control system. The following
information of the radio control system can be displayed and four of the settings
can be changed using this menu:
Code Information
001
Transmission speed (Baud rate) of the radio receiver on the CAN
bus
002
Node-ID of the radio receiver
003
Switching on and off the CAN heartbeat function
004
Entry of the crane identification
005
Display of the serial number of the radio receiver
006
Display of the software version of the radio receiver
007
Display of the hardware version of the radio receiver
Note:
Parameters 001 to 003 only refer to radio receivers with CAN interface and are
only effective for these. Parameters 001 to 003 are set in the factory and must not
be changed without prior agreement.
Attention:
Changes to the parameters of the radio receiver may impair functioning
of the hoist unit.
DRC-10:
•
Actuate and hold down the Stop key
•
Actuate the Lower key
•
Actuate the Right key twice
•
Actuate the Lower key again and hold it down for approx. 5 seconds
•
Release the Lower key again
•
Release the Stop key
DRC-J:
•
Lock the Stop key
•
Actuate
display
key
↓
•
Actuate
display
key
↓
twice
•
Actuate
display
key
↓
again and hold it down for approx. 5 seconds
•
Release
display
key
↓
again
Every change to the „Radio control parameter programming“ menu is signalled to
the crane control system.
1 Menu for programming parameters of the radio receiver
1.1 Activating the menu
Summary of Contents for DRC-DR D2
Page 1: ...Operating instructions DRC DR D2 radio receiver...
Page 18: ...18 21495344 indd 311007...
Page 26: ...26 21495344 indd 311007 Notes...
Page 27: ...27 21495344 indd 311007 Notes...
